No products in the cart.
800×480, 7.5inch E-Ink display HAT for Raspberry Pi
800×480, 7.5inch E-Ink Display HAT For Raspberry Pi, SPI Interface
This is an E-Ink display HAT for Raspberry Pi, 7.5inch, 800×480 resolution, with embedded controller, communicating via SPI interface.
Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
SPI interface, for connecting with other controller boards like Raspberry/Arduino/Nucleo, etc.
Onboard voltage translator, compatible with 3.3V/5V MCUs
Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
Operating voltage: 3.3V~5V
Outline dimension: 170.2mm × 111.2mm
Display size: 163.2mm × 97.92mm
Dot pitch: 0.205 × 0.204
Display color: black, white
Grey scale: 2
Full refresh time: 5s
Refresh power: 38mW(typ.)
Standby power: <0.017mW Viewing angle: >170°
Revision V2 has been released on 2019.11, the resolution is upgraded to 800×480, from 640×384 of V1. The hardware and interface of V2 are compatible with V1, however, the related software should be updated.
DIN SPI MOSI pin
CLK SPI SCK pin
CS SPI chip selection, low active
DC Data/Command selection (high for data, low for command)
RST External reset, low active
BUSY Busy status output, low active
7.5inch e-Paper HAT dimensions
7.5inch e-Paper x1
e-Paper Driver HAT x1
RPi screws pack (2pcs) x1
PH2.0 20cm 8Pin x1
Wiki : www.waveshare.com/wiki/7.5inch_e-Paper_HAT
There are no reviews yet.