No products in the cart.
250×122, 2.13inch E-Ink display HAT for Raspberry Pi
$25.99
Waveshare 12915 – 250×122, 2.13inch E-Ink display HAT for Raspberry Pi, SPI interface
This is an E-Ink display HAT for Raspberry Pi, 2.13inch, 250×122 resolution, with embedded controller, communicating via SPI interface, supports partial refresh.
Description
Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
Features
No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
Preserved solder pads for SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc.
Onboard voltage translator, compatible with 3.3V/5V MCUs
Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
Specifications
Operating voltage: 3.3V/5V
Interface: SPI
Outline dimension: 65mm × 30.2mm
Display size: 23.71mm × 48.55mm
Dot pitch: 0.194 × 0.194
Resolution: 250 × 122
Display color: black, white
Grey level: 2
Partial refresh time: 0.3s
Full refresh time: 2s
Refresh power: 26.4mW(typ.)
Standby power: <0.017mW
Viewing angle: >170°
DEMO
2.13inch e-Paper HAT demo
Interface
SYMBOL DESCRIPTION
VCC 3.3V/5V
GND Ground
NC NC
DIN SPI MOSI pin
CLK SPI SCK pin
CS SPI chip selection, low active
DC Data/Command selection (high for data, low for command)
RST External reset, low active
BUSY Busy status output, high active
Development Resources
Wiki : www.waveshare.com/wiki/2.13inch_e-Paper_HAT
Reviews
There are no reviews yet.