128×128, General 1.5inch OLED display Module

Description

This is an OLED display module, 1.5inch diagonal, 128×128 pixels, 16 gray scale, with embedded controller, communicating via SPI or I2C interface.
Features

128×128 high resolution
16 gray scale, better display effect
Supports SPI or I2C interface, configured via onboard resistor
Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)

Specifications

Driver: SSD1327
Interface: SPI / I2C
Display color: White
Gray scale: 16
Resolution: 128×128 (most other competitive products are typically 128×64)
Viewing angle: >160°
Operating voltage: 3.3V / 5V
Dimension: 44.5 x 37 (mm)

Interface
Symbol Description
VCC Power (3.3~5V input)
GND Ground
DIN Data input
CLK Clock data input
CS Chip selection, low active
DC Data/Command selection (high for data, low for command)
RST Reset, low active

There are two available drive interfaces for this OLED module: 4-wire SPI and I2C:
BS CS DC DIN CLK
4-wire SPI 0 Chip select Data/Command MOSI SCK
I2C 1 NC I2C address selection SDA SCL
Dimensions

Weight: 0.02 kg

1.5inch OLED Module dimensions
Package Contents

1.5inch OLED Module x1
PH2.0 7Pin x1

Development Resources

Wiki : www.waveshare.com/wiki/1.5inch_OLED_Module